Under the post-payment, the session is paid for after its end. Payment is calculated on a per minute basis. This pass cannot be purchased from the client Shell, it is sold by the operator for unauthorized clients.
Enabling and setting
To enable the post-payment, go to Settings -> Admin Panel, enable the post-payment and specify its maximum duration (from 5 to 1440 minutes).
Then create a per-minute pass if it has not been created yet. The post-payment cost per minute will be equal to the cost of the current per-minute pass, specified in the For everyone column.
Usage and payment
To use the post-payment, right-click on the PC and select Post-payment in the Gaming stations or the Map tab.
A session can end in two cases:
- The session is ended by the operator.
- The session is ended due to reaching the maximum session length under the post-payment.
In the first case, you need to right-click on the PC - End Session, after which the payment window will appear:
In the second case, a pop-up window will appear in the lower right corner of the admin panel with information about the session end. A notification will also appear near the Payments tab with the number of pending post-payments.
In the Payments tab you will see a line with the Post-payment payment type and the Pending status. To male a payment, click on it and on the right side of the payment information, then click on the Go to payment button, after which the payment menu will appear.
It is possible to make a billing without payment in both cases. To do this, click on the cancel button in the payment window, enter a comment and your password. In this case the status will change to Unpaid.
IMPORTANT NOTICE!
You can't end a shift with pending post-payments.